®
Keurig Brewer De-Scaling Instructions
Brewer Model: Elite B40 | Classic B44
Special Edition B60 | Platinum B70
Brewer Model: MINI Plus B31
To begin, you will need the following:
• 20 oz. of undiluted white vinegar
• 12 oz. ceramic mug (do not use a paper cup)
• Access to an empty sink
To begin, you will need the following:
• 48 ounces of undiluted white vinegar
• Large ceramic mug (do not use a paper cup)
• Access to an empty sink
PREPARE
FILL, CLEAN AND RINSE
Step 1: Empty the water in the Water Reservoir.
Step 2: Disable “Auto Off” features.
Step 1: First Vinegar Rinse
• Fill the Cold Water Reservoir with 10 oz. of undiluted
white vinegar.
• Place the ceramic mug on the Drip Tray.
• Lift the Brewer Handle, but DO NOT ADD A K-CUP.
• After 5 seconds, lower the Brewer Handle.
• Press the flashing blue BREW Button. It will flash
red and then turn solid red.
• Once the vinegar is dispensed, discard hot contents
into sink.
FILL AND CLEAN
Step 1: Pour approximately 48 ounces of the vinegar
into the Water Reservoir.
Step 2: Place a large mug on the Drip Tray Plate and
run a brew cycle. DO NOT USE A K-CUP, just
press the BREW Button. Pour the contents of
the large mug into the sink.
Step 3: Repeat the brew process without a K-Cup until
“ADD WATER” is indicated.
Step 4: Now let the Brewer stand for at least 4 hours
while still on.
Step 5: Discard any residual vinegar and rinse the
Water Reservoir thoroughly.
Step 2: Second Vinegar Rinse
• Pour the remaining 10 oz. of vinegar into the Cold
Water Reservoir.
• Place the ceramic mug on the Drip Tray.
• Lift the Brewer Handle, but DO NOT ADD A K-CUP.
• After 5 seconds, lower the Brewer Handle.
• Press the flashing blue BREW Button. It will then
flash red.
• When it turns solid red, power off as it starts to
dispense.
RINSE
Step 1: Ensure the Water Reservoir is filled with fresh
water.
• Allow Brewer to sit for 30 minutes.
• Power on the Brewer, lift and lower Brewer Handle,
then press BREW Button.
• Once the vinegar is dispensed, discard hot contents
into sink.
Step 2: Place a large mug on the Drip Tray Plate and
water brew cycle. Pour the contents of the
large mug into the sink.
Step 3: Repeat brew process until “ADD WATER” is
indicated.
Step 4: You may need to perform additional water brew
cycles if you notice any residual taste.
Step 3: Fresh Water Rinse
• Fill the Cold Water Reservoir with 10 oz. of fresh
water.
NOTE: If “DE-SCALE” is still displayed after
completing the procedure, repeat the
de-scaling procedure above.
• Place the ceramic mug on the Drip Tray.
• Lift the Brewer Handle, but DO NOT ADD A K-CUP.
• Lower Brewer Handle and continue the brewing
process until the hot water is dispensed into the
mug. Discard hot contents into sink.
• Repeat this cleansing brew process three (3) more
times to cleanse the Brewer plumbing and to
remove any residual vinegar taste. The Brewer is
now ready for normal use again.
© 2011 Keurig, Incorporated All Rights Reserved.
|
John Lewis Oven JLBIOS603 User Manual
JVC CRT Television 0303 NIC JMT User Manual
Kenmore Range 790367 User Manual
Kenwood Car Amplifier KAC M645 User Manual
Kenwood Cassette Player KRC 791 User Manual
Kenwood Home Theater System KRF V5020 User Manual
KitchenAid Blender KCB148 User Manual
KitchenAid Water Dispenser KHWG160PCR User Manual
Klipsch Speaker HS1 User Manual
Konica Minolta Printer 2550DN A00V014 User Manual