JPM610A-R7
JPM612A-R7
JPM614A-R7
GigaTrue® CAT6 Component Level Patch Panels
Make patching transitions from horizontal cable
to typical stranded cable.
Meet Category 6 component performance requirements.
Order toll-free in the U.S.: Call 877-877-BBOX (outside U.S. call 724-746-5500)
Customer
Support
Information
FREE technical support 24 hours a day, 7 days a week: Call 724-746-5500 or fax 724-746-0746
Mailing address: Black Box Corporation, 1000 Park Drive, Lawrence, PA 15055-1018
GigaTrue CAT6 Component Level Patch Panels
Figure 1. Color codes for T568A/TS568B wiring on the wiring label.
NOTE: For best performance, keep the untwisted part of the wire less than 0.5 inches (1.3 cm) long.
Using a punchdown tool, terminate each wire. Push the 110 punchdown tool to the edge of the 110 connector to trim the
conductors. See Figure 2.
Figure 2. Terminating the wire conductors.
Page 3
4. Optional: Place the stuffer caps on the terminated 110 blocks for added strain relief.
5. Finally, connect the patch cord. Plug the patch cord into the patch panel, then connect it to the network equipment.
Installation is complete.
About Black Box
Black Box provides an extensive range of networking and infrastructure products. You’ll find everything from cabinets and racks
and power and surge protection products to media converters and Ethernet switches all supported by free, live 24/7 Tech support
available in 30 seconds or less.
© Copyright 2012. Black Box Corporation. All rights reserved. Black Box®, the Double Diamond logo, and GigaTrue® are registered trademarks of BB
Technologies, Inc. Any third-party trademarks appearing in this manual are acknowledged to be the property of their respective owners.
JPM610A-R7, version 1
724-746-5500 | blackbox.com
|