Bosch Power Tools Welding Consumables VDN 240 User Manual

VDN-240 / VDC-240 / VDI-240 - Quick Install  
1/2  
VDN(C)-240  
VDI-240  
1
2
3
4
VDN(C)-240  
VDI-240  
4x Anchors  
Video  
GND  
Guide pattern  
Rubber pad  
DOWN  
DOWN  
GUI  
GUIDE  
DE P  
AT  
PAT  
TERN  
TERN  
BNC  
female  
Conduit cap  
Dome base  
1 Vpp  
75 Ohm  
4x screws  
24 VAC / 12 VDC  
Class 2  
Pan  
Pan  
Twist  
Zoom  
Focus  
Tilt  
Twist  
Tilt  
Menu (set)  
Dome cover  
Wrench  
Zoom  
Focus  
IR LEDs  
DOWN  
Service cable  
1.2  
Important safety instructions  
1. Read these instructions.  
2. Keep these instructions.  
3. Heed all warnings.  
1.4  
Bosch notices  
1.3  
FCC & ICES compliance  
FCC & ICES Information  
1
Safety  
Disposal - Your Bosch product was developed and  
This equipment has been tested and found to comply with the  
limits for a Class A digital device, pursuant to part 15 of the  
FCC Rules. These limits are designed to provide reasonable  
protection against harmful interference in a residential  
environment. This equipment generates, uses, and can radiate  
radio frequency energy and, if not installed and used in  
accordance with the instructions, may cause harmful  
interference to radio communications. However, there is no  
guarantee that interference will not occur in a particular  
installation. If this equipment does cause harmful interference  
to radio or television reception, which can be determined by  
turning the equipment off and on, the user is encouraged to try  
to correct the interference by one or more of the following  
measures:  
manufactured with high-quality material and components that  
can be recycled and reused. This symbol means that  
electronic and electrical appliances, which have reached the  
end of their working life, must be collected and disposed of  
separately from household waste material. Separate collecting  
systems are usually in place for disused electronic and  
electrical products. Please dispose of these units at an  
environmentally compatible recycling facility, per European  
Directive 2002/96/EC  
1.1  
Safety precautions  
DANGER!  
4. Follow all instructions  
High risk: This symbol indicates an imminently hazardous  
situation such as "Dangerous Voltage" inside the product.  
If not avoided, this will result in an electrical shock, serious  
bodily injury, or death.  
5. Do not use this apparatus near water.  
6. Clean only with a dry cloth.  
7. Install in accordance with the manufacturer's instructions.  
8. Do not install unit near any heat sources such as radiators,  
heat registers, stoves, or other apparatus (including  
amplifiers) that produce heat.  
WARNING!  
9. Protect the power cord from being walked on or pinched  
particularly at plugs, convenience receptacles, and the  
point where they exit from the apparatus.  
Medium risk: Indicates a potentially hazardous situation.  
If not avoided, this could result in minor or moderate bodily  
injury.  
Optical elements  
Optical elements are sensitive and should be protected at all  
times. Do not allow objects to come into contact with glass  
surfaces and do not touch optical elements with your fingers.  
10. Only use attachments/accessories specified by the  
manufacturer.  
CAUTION!  
11. Unplug this apparatus during lightning storms or when  
unused for long periods of time.  
reorient or relocate the receiving antenna;  
increase the separation between the equipment and  
receiver;  
Low risk: Indicates a potentially hazardous situation.  
If not avoided, this could result in property damage or risk of  
damage to the unit.  
Copyright  
This manual is the intellectual property of Bosch Security  
Systems and is protected by copyright.  
All rights reserved.  
12. Refer all servicing to service personnel. Servicing is  
required when the apparatus has been damaged in any  
way, such as power-supply cord or plug is damaged, liquid  
has been spilled or objects have fallen into the apparatus,  
the apparatus has been exposed to rain or moisture, does  
not operate normally, or has been dropped.  
connect the equipment into an outlet on a circuit different  
from that to which the receiver is connected;  
consult the dealer or an experienced radio/TV technician  
for help.  
CAUTION!  
Trademarks  
The Low Voltage power supply unit must comply with EN60950  
/ UL60065. The power supply must be a SELV-LPS unit or a  
SELV - Class 2 unit (Safety Extra Low Voltage - Limited Power  
Source).  
All hardware and software product names used in this  
document are likely to be registered trademarks and must be  
treated accordingly.  
Intentional or unintentional modifications, not expressly  
approved by the party responsible for compliance, shall not be  
made. Any such modifications could void the user's authority to  
operate the equipment. If necessary, the user should consult  
the dealer or an experienced radio/television technician for  
corrective action.  
Note  
CAUTION!  
Bosch Security Systems accepts no liability for damage  
resulting directly or indirectly from faults, incompleteness or  
discrepancies between the user guide and the product  
described.  
Installation should only be performed by qualified service  
personnel in accordance with the National Electrical Code or  
applicable local codes.  
More information  
For more information please contact the nearest Bosch Security  
Systems location or visit www.boschsecurity.com  
AM18-Q0630  
 

Black Box Computer Hardware IC181C User Manual
Black Box Security Camera Blackbox IP Security Camera and Accessories User Manual
Bogen Water Heater WMT 1A User Manual
Bolens Lawn Mower 112 413R352 User Manual
BOXLIGHT Projector CD 450m User Manual
Bravetti Electric Grill EP865 User Manual
Canon Camcorder 115U User Manual
Chauvet Indoor Furnishings SCAN LED 100 User Manual
Christie Digital Systems Projector LW300 User Manual
Cisco Systems Conference Phone CP7921GAK9RF User Manual