S200X Suspension Seat Kit
Installation
Part No. 5600136
For Snapper Pro S200X Models (5900664 & 5900692)
Instructions
Kit Contents:
Part No.
5101214
5401044D
5403471D
5101123
5025010X6
5025391
5025154
Qty. Description
A
1
1
1
1
1
1
1
Suspension Seat
Extension, Seat Belt
Plate, Seat Support
Sleeve Buckle, Seat Belt
Bolt, 1/4-20 X 3/4 GD5 YZ
Nut, 1/4-20 Hex Nylock Flange
Washer,1/4 SAE
WARNING
Before beginning any service work turn off the
PTO, set the parking brake, turn off the ignition,
and disconnect the spark plug wire(s).
A
Figure 1. Remove The Existing Seat
A. 5/16-18 Nylock Flange Nuts
B. Seat Plate
Installing The Suspension Seat
1. Park machine on a flat, level surface and engage the
parking brake. Disengage the PTO switch, turn off
the engine and remove the key from the ignition.
2. Raise the seat plate (B, Figure 1) to gain access to
the four (4) 5/16-18 nylock flange nuts (A) that
secure the existing seat to the seat plate.
A
3. Remove the four (4) 5/16-18 nylock flange nuts and
remove the seat from the seat plate. Retain the four
(4) 5/16-18 nylock flange nuts.
B
C
D
4. Using the 1/4 hardware secure (B, C & D, Figure 2)
the seat support plate (A) to the seat plate.
5. See Figure 3. Install the new suspension seat onto
the seat plate and secure using the four (4) 5/16-18
nylock flange nuts that were removed in step 3.
Left Side View of
Seat Plate
D
Installing The New Seat Belt Components
C
B
6. See Figure 4. On the right hand side of the
machine, replace the existing seat sleeve buckle with
the new seat sleeve buckle. Replace the existing
seat belt extension plate with new seat belt extension
plate.
A
Figure 2. Install the Seat Support Plate
A. Seat Support Plate
B. 1/4-20 X 3/4 Bolt
C. 1/4 SAE Washer
D. 1/4-20 Hex Nylock Flange Nut
Briggs & Stratton Yard Power Products Group
Copyright © 2007 Briggs & Stratton Corporation
Milwaukee, WI, USA. All Rights Reserved.
5403602
Rev. 8/2007
TP 200-7344-00-SK-SP
1
|