Nomenclature
●①
●②
●③
●④
●⑤
●⑥
EF55-200mm f/4.5-5.6 USM
EF55-200mm f/4.5-5.6 II USM
EF80-200mm f/4.5-5.6 USM
Zoom ring
Zoom position index
Contacts
Lens mount index
Focus mode switch
Focusing ring
EF Zoom Lenses
EF55-200mm f/4.5-5.6 USM
EF75-300mm f/4-5.6 II USM
EF75-300mm f/4-5.6 III USM
EF90-300mm f/4.5-5.6 USM
y
EF55-200mm f/4.5-5.6 II USM
EF80-200mm f/4.5-5.6 USM
Instructions
Thank you for purchasing a Canon product.
Safety Precautions
2. Setting the Focus Mode
●❸
●❶
To shoot in autofocus (AF) mode, set the focus mode switch
❹
to AF
.
1. Do not look at the sun or a bright light source through
the lens or camera. Doing so could result in loss of
vision. Looking at the sun directly through the lens is
especially hazardous.
2. Whether it is attached to the camera or not, do not
leave the lens under the sun without the lens cap
attached. This is to prevent the lens from concentrating
the sun’s rays, which could cause a fire.
To shoot in manual focus (MF) mode, set the focus mode
switch to MF, and focus by turning the focusing ring.
• Do not touch the rotating parts of the lens while AF is
active.
• Do not focus in MF when the focus mode switch set
AF.
• When the hood (sold separately) is instalthe EF5
200mm f/4.5-5.6 USM, EF55-200mm fUSM
and EF80-200mm f/4.5-5.6 USM, you cae hood
to adjust with MF.
●❷ - ●Ⓐ
●❷ - ●Ⓑ
●❹
●❺
Handling Cautions
3. Zooming
If the lens is taken from a cold environment into a warm
one, condensation may develop on the lens surface and
internal parts. To prevent condensation in this case, first
put the lens into an airtight plastic bag before taking it
from a cold to warm environment. Then take out the lens
after it has warmed gradually. Do the same when taking
the lens from a warm environment into a cold one.
To zoom, turn the lens’ zoom
• Be sure to finish zng be. Changing the
zoom ring after cusing can cus.
1. Mounting and Detaching the Lens
See your camera’s instructions for details on mounting
and detaching the lens.
• After detaching the lens, place the lens with the rear end
up to prevent the lens surface and contacts from getting
scratched.
• If the contacts get soiled, scratched, or have fingerprints
on them, corrosion or faulty connections can result. The
camera and lens may not operate properly.
• If the contacts get soiled or have fingerprints on them,
clean them with a soft cloth.
• If you remove the lens, cover it with the dust cap. To
attach it properly, align the lens mount index and the
❶
index of the dust cap as shown in diagram , and turn
clockwise. To remove it, reverse the order.
|