MA0309-EA
Operation Guide W-CLO.G
<Type 1>
• A sticker is affixed to the display of this clock when you purchase it. Be sure to remove the sticker before using
the clock.
• Depending on the clock model, the configuration of your clock may differ somewhat from that shown in the
illustration.
TO START CLOCK
Insert a battery into battery compartment (1) with polarity as indicated.
TO SET TIME
Turn the hour/minute adjuster (2) in either direction.
TO ADJUST SECONDS
<Type 1>
Remove the battery to stop the second hand at 12 o’clock position. Replace the battery at a time signal to restart
the second hand on the correct second.
<Type 2>
Slide switch 3 to the STOP setting to stop the second hand. Slide 3 to START on a time signal to restart the
second hand.
• The start of second hand may be delayed depending on the timing of your switch operation.
<Type 2>
REPLACING THE BATTERY
Low battery power is indicated when timekeeping slows or stops completely. Should either of these symptoms
occur, replace the battery immediately. Do not leave a low or dead battery in the clock.
1. Remove the old battery.
2. Load a new battery, making sure that its positive (+) and negative (–) ends are facing correctly. Loading a battery
incorrectly can cause it to burst and damage the clock.
Battery precautions
• Keep batteries out of the reach of small children. If a battery is accidentally swallowed, contact your physician
immediately.
• Be sure to load the battery with its positive (+) and negative (–) ends facing correctly.
• Never charge the battery that comes with the clock.
• Should a battery ever leak while in the clock, wipe out the fluid with a cloth, taking care not to let any get onto
your skin.
• Replace the battery at least once a year, even if the current battery is working normally.
• The battery that comes with the clock loses some power during transport and storage.
1
|