TQ-450/550
Next alarm dial
Alarm ON/OFF switch
Time setting dial
SNOOZE(/LIGHT)
T
A
A
ON
60
5
55
10
OFF
50
RESET
RESET
Hour hand
Minutes Hand
ALARM
2 0
Seconds hand
Alarm Hand
4 0
2 5
3 5
3 0
Battery compartment
Alarm setting dial
• The configuration of your clock may differ somewhat from that shown in the illustration.
• This clock employes a face that is designed to collect light and make figures on the display
easier to read. (TQ-550 only)
TO SET THE ALARM
1. Rotate the Alarm setting dial in the direction indicated by the arrow marked on clock to move the
alarm hand to the 1st Alarm time setting you want.
• Pressing SNOOZE/LIGHT illuminates the face of the clock for about three seconds for easy
reading of the time in the dark. (TQ-550 only)
2. Rotate the NEXT ALARM dial from 1st Alarm to the Next Alarm setting you want to use.
• You can set the Next Alarm to any time from 5 to 60 minutes, in 5-minute steps.
3. Set the Alarm ON/OFF switch to ON .
TO SET THE TIME
• If the Alarm ON/OFF switch is already set to ON, always be sure to change its setting to OFF and
then back to ON again after making alarm time setting changes.
Rotate the Time setting dial to change the time setting.
• Note that this clock does not distinguish between AM and PM times. If you set an alarm to wake
up to in the morning, the alarm will sound again at the same time in the evening if you leave the
Alarm ON/OFF switch in the ON position.
• Be sure to always press RESET with a thin object after loading batteries.
USING THE ALARM
This clock has two alarms. The 1st Alarm is the alarm that sounds when the current time reaches
the alarm time you set. The Next Alarm sounds after passage of the time setting of the NEXT
ALARM dial, starting from the point that the 1st alarm begins to sound. The Next Alarm also has a
snooze feature.
TO USE THE ALARM
The 1st Alarm starts to sound when the current time reaches the time indicated by the alarm hand.
The 1st Alarm stops sounding when you press SNOOZE(/LIGHT) or after it has sounded for about
one minute. After the amount of time set by the Next Alarm Dial passes, the Next Alarm starts to
sound. Pressing SNOOZE(/LIGHT) stops the Next Alarm sound for about five minutes, after which
it starts to sound again. In all, the Next Alarm will sound seven times.
The alarm on/off setting affects both the 1st Alarm and the Next Alarm. You cannot turn the 1st
Alarm and Next Alarm on and off individually.
The Next Alarm sound is relatively louder than the 1st Alarm sound.
If you do not press SNOOZE(/LIGHT) after the Next Alarm starts to sound, it will stop automatically
after about one minute.
To deactivate the snooze feature so the alarm will not sound again, change the Alarm ON/OFF
switch setting to OFF.
|