I N S T A L L A T I O N I N S T R U C T I O N S
Instrucciones de instalación
Installationsanleitung
Istruzioni di installazione
Installatie-instructies
Instruções de Instalação
Instructions d´installation
Automated Dual Horizontal Door System
This device complies with part 15 of the FCC rules. Operation is subject to the following 2 conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits of a Class B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate
radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio or television
communications. However, there is no guarantee that the interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one of the following measures:
•
•
•
Reorient or relocate the receiving antenna
Increase the separation between the equipment and receiver
Connect the equipment to an outlet on a circuit other than that to which the receiver is connected
Consult the dealer or and experienced radio/TV technician for help
CM6DH SERIES
CM6DH SERIES
Installation Instructions
TOOLS REQUIRED FOR INSTALLATION
1/2" (12.7mm)
#2
PARTS
A (1)
B (1)
G (1)
C (2)
F (2)
D (1)
08 x 1/2"
E (1)
3
CM6DH SERIES
Installation Instructions
Installing to Cabinet
INSTALLATION
1. Place mechanism (A) on top of cabinet. (See Figure 1)
2. Align center of track with center of the door opening.
3. Attach using #8 or #10 screws through the holes in track.
Cabinet Considerations
1. Header must not extend beyond top of track.
2. Guide wheel must have free play in toe space.
3. Doors must not exceed 50 lbs (each).
4. Allow ample room for drawers to open past doors, and
for doors to move in front of cabinet, as well as above
floor or carpet.
4. Attach motor box to the track following instructions in box.
(See Figure 2)
5. Use of a quality surge protection device is suggested
for mounting on top of cabinet to make electrical
hook-up of the mechanism and lights.
4
Installation Instructions
CM6DH SERIES
Figure 1
5
|