Step 3:
Plug Conserve power cord into the wall outlet.
Step 4:
Remove the remote switch and wall-mount from
the box.
Mounting screws are not included; see User Guide for
wall-mount installation.
Step 5:
Pull and remove the clear battery tab from the
back of the remote switch.
Remove
Pull
before using.
Step 6:
Firmly press and release the “|” button to turn ON
the “Remote Switched” outlets.
Check to see if a green light flashes on the remote switch. This will
indicate that the remote is working.
6
I = ON
O = OFF
Step 7:
Your equipment is now powered,
surge-protected, and ready for use.
Step 8:
When finished using your equipment, turn off
each device as you normally would.
HOW TO USE THE
CONSERVE REMOTE SWITCH
Step 9:
When your equipment is off, firmly press and
release the “O” button on the remote switch.
Check to see if a green light flashes on the remote switch. This will
indicate that you have eliminated standby power to Conserve’s
“Remote Switched” outlets. Devices plugged into the “Always On”
outlets will remain powered.
I = ON
O = OFF
9
Step 10:
When ready to use your equipment again, firmly
press and release the “|” button on the remote
switch to activate the power to the “Remote
Switched” outlets.
Step 11:
Turn on and use your equipment as normal.
Repeat Step 8 when done.
For complete instructions, see the User Guide
|